|
Software
V44/V88 calibration software Version 4.2 VTS_V4-2_Setup.exe
(14-09-08)
The software has very good online help.
Right click on any item and select "Whats this?". To
change table axis right click on the table and select
"axis setup" . Look under the help menu for "hotkeys"
--------------------------------------------------------------------------------
Firmware
V44/V88 Firmware Upgrade Version 4.2.0 ViPEC4-2-0.exe
(14-09-08)
Changes in this version
--------------------------------------------------------------------------------
Acceleration Timer "version 1.0" New
Record vehicle speed from 0 to any speed up to 300
km/h, also acceleration from 60, 100, 160 to 300 km/h.
Results are displayed in a graph with split times. Works
with V44 and V88 ECU models. Requires vehical speed
input to ECU Screen shots of interface
and graph.
(278k) AccelTimer.exe
------------------------------------------------------------------------------
Virtual Dash
Display in analog gauges the real time data stream from
V44/V88 ECU. Calculates the HP produced by the engine.
Data can be saved to file and then viewed or rerun.
Saved files can be exported into a comma delimited file
that can be imported into Excel. Record acceleration
of the vehicle and display the information in an acceleration
graph that can be saved as a BMP file. Power graph engine
power (produces graph similar to those produced by a
dynamometer pull)
VDas.exe (228K)
-------------------------------------------------------------------------------
Injection Range
Shows the fuel injection period over the 720 degrees
of the engine cycle compared to the inlet valve open
period. InjectRange.zip
(176k)
--------------------------------------------------------------------------------
Injector Size
TurboFast - Injector calculator. InjSize.zip
(176k). Find injector flow per cylinder and total engine
fuel flow. Also find HP per cylinder an injector will
provide.
--------------------------------------------------------------------------------
Signal Generator
TurboFast - Signal Generator. SignalGen.zip
(143k). Uses a parallel port to output 0 to 5v square
wave for cylinder pulse, and a single 0 to 5v reference
pulse. Signal Generator will allow an ECU to be run
at various rpm's to test injectors, ignition outputs
and many more items, without physically running the
engine. Ideal for testing items before first start.
Includes diagram showing 25 pin printer cable connector
wiring.
|
